Enforcer Keypad Manual. Push connected wires through the hole in the wall, taking. The wiring hole should be at least ø11/4″ (ø 3cm).
ENFORCER SK1011SDQ Installation guide Manualzz from manualzz.com
Web the right led turns green to put the keypad in stan dby mode. Reattach the keypad to the mounting base. Use the included torx wrench.
Using The Keypad Entering A User Code • To Activate Either Output #1.
Model numbers that end with q or that have a. Programming format and default programming values: Please the use timestamps below to get to the desired location.
The Wiring Hole Should Be About Ø11 /4″ (Ø3Cm).
Web the right led turns green to put the keypad in stan dby mode. U u u u indicates a. Web reprogram the keypad (certain data) to change certain data in the keypad (such as to delete or change user codes), do the following:
Push Connected Wires Through The Hole In The Wall, Taking.
The wiring hole should be at least ø11/4″ (ø 3cm). Web drill the five holes. Connect wires and push through the hole in the wall, taking care not to.
Page 5 Digital Access Keypad Manual Digital Access Keypad Manual Programming Notes.
The master code can be used to operate the door or program the keypad. Use the included torx wrench. Reattach the keypad to the mounting base.
In This Manual, The Format Used For Programming The.
Connect each of the wires that will be used to operate the keypad according to the wiring diagram 8. Enter programming mode and begin again.
